Document sans titre

 

 

IF-ToolPrecision

Cutting edge measurement of taps with IF-ToolPrecision

High resolution measurement of roughness, form, contour and roundness



toolprecision-if

See magazine


IF-ToolPrecision at a glance

  • The system: automatic cutting edge measurement by 360° 
  • The function: roughness measurement, form measurement, contour measurement
  • The benefits: areal based measurement at high user-friendliness
  • The application: high resolution measurement of taps and shaft tools
  • The technology: Focus-Variation for areal based surface measurement 


The function: roughness measurement, form measurement, contour measurement


puce_top

Users measure form, roughness, and contour including roundness. In research and development the tool inspection system is used for tool optimization. In production integrated quality assurance the system is mainly applied to measure tap tools.

 

The benefits: areal based measurement at high user friendliness


puce_top

IF-ToolPrecision performs high resolution measurements and is intuitively operated. There are no time consuming calibration routines necessary as the insertion of the tool is very simple with auto calibration included. This increases both measurement speed and accuracy. Results include OK/NOT OK status, tolerances and are visualized in registered color information.

 

The application: high resolution measurement of taps and shaft tools


puce_topIn tool development, IF-ToolPrecision is used to optimize shaft tools such as drills, milling cutters etc. When used in the automatic mode, the system is applied for the automatic measurement of user defined parameters of taps. Users measure up to 30 parameters throughout the 360° rotation of tools. Usually, these parameters are measured via at least two different measurement systems.

 

 

The technology: Focus-Variation for areal based surface measurement


puce_topIF-ToolPrecision is based on Focus-Variation. The optical technology delivers a measurement point density of more than 100 mil measurement points which enables form and roughness measurement of even large measurement areas and volumes. As an area based technology, Focus-Variation is already included in the most recent EN ISO standard 25178. With each measurement, users automatically receive data for evaluating the measurement uncertainty.

 
 

Further information


puce_top_rouge


Contact us

 

Full name : First name :
Company : Tel :
E-mail :    



Commentaries :